EZConsole is Copyrighted 2000 
by Dustin Miller (Lord-X)

Coded by: Lord-X
Graphics/Design: Netrat
Graphics Assistance: {dk} Dave


Installation: 
	Unzip all the files to a directory, and run EZConsole.exe.  On the main screen, press the button 'Click Here To Start'.  It will display the information below, and take you to the new profile's screen.


Tips on using EZConsole:
-Click on the 'EZControl', 'ServerConfig', and 'Missions' images to refresh those displays.
-To Kick/Ban, Admin, or remove Admin rights from players, right click in the players list box;
-To change a players team, drag them to the other team (or to observer)
-To change the team name, click on the team name.  Wait a second and click on the team name again to enter the edit mode.
-To set team skins, right click on the team name.
-To pause, save, clear, or change the filers on the server console, right click on the console window.
-Pressing enter in the Message Center window broadcasts the typed message to the server(s).
-Right click on the profiles boxes to create/edit profiles.
-Read all the text inside the program.  If you don't understand something, or there seems to be a problem, then send email to ezconsole@planetstarsiege.com.  We have put a lot of time into this program to make it EZ to use.  So, if it seems difficult, you are probly doing it wrong.


---------------


EZConsole is a remote admin utility for Starsiege Tribes.

It telnets to the server and enters the sometimes combursome admin commands
for you, at the push of a button.  But, in order for EZConsole to connect to
your server, you MUST have these lines in your serverconfig.cs file:

$TelnetPort=1001;
$TelnetPassword="password";

Use your own port and password, but sometimes numbers under 1000
do not work.

When you press OK, you will be taken to the profiles screen.  Here you setup
the profile for the server you are administrating.  Fill in all the fields and press OK.

Profile Name: Name to refer to this server.  It is not the name of the server, just
a way to identify it in EZConsole

Server IP: IP Address of the server

Server Port: Telnet port for the server.  (1001 for the above example)

Server Password: Telnet password for the server ("password" for the above 
example)

Bandwidth Monitoring Port: Port used to connect to EZServer.  This provides
real time bandwidth utilization of the server.

Connect at start: Check this box if you want EZConsole to conect to this server
when the program starts.

Save Password: Check this box if you want EZConsole to store the telnet 
password in the ezconsole.cfg file.

Proxy/Firewall Support:  Check this box if you want EZConsole to interact with a
proxy/firewall.  This is done through a list of 'Wait For' and 'Send' messages.
This is intended for advanced users only.
